update Updated: 11/15/2018
For the Wanhao duplicator6, you will need to print these files, already oriented as needed. Here are a few recommendations for printing:
File | Material | Layer Height | Supports | Infill | Download |
---|---|---|---|---|---|
STLM200ZortraxSuctionHead.STL | ABS/ULTRA | 0.09 | NO | HIGH | |
STLM200CLIP-P1-Hose-Holder.STL | ABS/ULTRA | 0.19 | NO | HIGH | |
STLM200CLIP-P2-Hose-Holder.STL | ABS/ULTRA | 0.19 | YES | HIGH | |
STLM200ExtruderCableSupport.STL | ABS/ULTRA | 0.19 | NO | HIGH |
This is your last print without Zimpure!
Mount the CLIP-P1-Hose-Holder into the CLIP-P2-Hose-Holder. Then, unplug the original CLIP-P2-Hose-Holder and clip your new one.
Insert the back to back Velcro tape into the ZortraxSuctionHead. Then, place the adapter on the bottom side of your extruder as shown on the picture below. Tighten the back to back Velcro tape as shown on the second picture below.
Insert the hose into CLIP-P2-Hose-Holder, and push to the Zortrax suction head. Hold the sunction head while inserting the hose into it. Clip the hose in the HoseHolderChassis. Push the CableExtruderSupport to prevent damaging the extruder connection. Then, insert the Hose into your Zimpure.
Here you go, your Zimpure is ready to filter! You need to turn it ON only after than your Zortrax has started to print. Please verify how the beginning of the first layer goes. You are now all set up to print safely, without any toxic emissions. You can see how Zimpure is efficient by smelling on the top of Zortrax. No more bad and hazardous ABS smelt! Happy safe printing!