3d printer air filter - Wanhao duplicator4

update Updated: 11/15/2018

Zimpure - Wanhao duplicator4 instructions build





  • Step 1. Print the adapters


    For the Wanhao duplicator4, you will need to print these files, already oriented as needed. Here are a few recommendations for printing: 

    File Material Layer Height Supports Infill Download
    STLCreatorProFlashForgeSuctionHeadV4.STL ABS 0.1 NO HIGH
    file_download

    Creative Commons License
    This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.


    This is your last print without Zimpure!

  • Step 2.Installing the FlashForge Suction Head

    Unscrew the two screws of the plastic part which holds the filament guide and remove it. Place the FlashForge Suction Head at this place as shown on the picture below. Rescrew these two screws.

    duplicator4/imgStep/CreatorPro/instructions2.jpg
  • Step 3.Installing the Hose

    Insert the hose into Wanhao duplicator4 holder and plug the other side of the hose into Zimpure.

    duplicator4/imgStep/CreatorPro/instructions3.jpg
  • Step 4. Operating Instruction

    Here you go, your Zimpure is ready to filter! First, depending on the cooling fan you’re using, you could have to lower it to have a suction rate efficient enough.

    Please note that you need to turn your Zimpure ON only after than your duplicator4 has started to print. Please verify how the beginning of the first layer goes. You are now all set up to print safely, without any toxic emissions. Happy safe printing!