update Updated: 11/15/2018

Zimpure - Ultimaker 2 instructions build

• Step 1. Print the adapters
  
  
  

  
  

  For the Zortrax M200, you will need to print these files, already oriented as needed. Here are a few recommendations for printing: 
  

  File	Material	Layer Height	Supports	Infill	Download
  STLOriginal+Holder.stl	Flexible	0.1	YES	HIGH	file_download
  STLOriginal+Tube.stl	Flexible	0.1	YES	HIGH	file_download

  
  
  This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

  
  
  

  It's recommended to print these parts with a filament a little flexible to make it clip easily.
  

  Thanks to Oscar Galego from bikespot for this nice design!
  

• Step 2. Installing the Ultimaker 2 Suction Head

  First, install the Ultimaker 2 suction head that you downloaded above on your extruder.

  

  
• Step 3. Installing the Hose

  Then, insert the hose into the 2 Suction Head and plug the other side of the hose into Zimpure. 

• Step 4. Operating Instruction

  Here you go, your Zimpure is ready to filter! First, depending on the cooling fan you’re using, you could have to lower it to have a suction rate efficient enough.
  
  Please note that you need to turn your Zimpure ON only after than your 2 has started to print. Please verify how the beginning of the first layer goes. You are now all set up to print safely, without any toxic emissions. Happy safe printing!